Rd130

120° V-groove router bit for Zund router modules with a 0.236 in (6.0 mm) collet. 2-flute 120° V-bit with a 0.394 in (10.0 mm) cutting diameter and a 0.039 in (1.0 mm) bottom diameter on a 0.236 in (6.0 mm) shank.

Sold individually.

120° V-groove

The Rd130 cuts a 120° V-groove up to 0.157 in (4.0 mm) deep, with a 0.039 in (1.0 mm) flat at the bottom of the groove. Use it for V-grooving, chamfered edges, and decorative line work on sign and display panels.

Double-edged, fine grain carbide

Two cutting edges split the work, which leaves a smoother groove wall than a single edge. The bit is ground from fine grain carbide, which holds a sharp edge longer than steel in production.

Common questions

How do I know this fits my machine?

The Rd130 has a 0.236 in (6.0 mm) shank and fits Zund router modules that take 6 mm bits. Not sure? Send us your machine model and we will confirm before you order.

How do I know when to replace it?

Watch the groove. Burrs, chipped groove walls, or a V-profile that no longer cuts clean and even all mean it is time for a fresh bit.

Getting the most from your cutting table

A fresh bit is a good start. But if you are going through bits faster than expected, or edge quality has become inconsistent, the bit is rarely the whole story. Spindle speed, feed rate, depth per pass, material hold-down, and machine condition all affect how long a bit lasts and how clean it cuts.

It is worth asking: When was your machine last serviced? Are your parameters dialed in for this material? Is this the right bit for what you are cutting? Could your operators use time with someone who runs these machines every day?

Flatbed Tools offers machine service, preventive maintenance, operator training, and workflow consulting. If something is not cutting right, reach out. We have probably seen it before.